2008 Sany SCC3200 – 350 ton Hydraulic Crawler Crane
275'-7" of Lattice Boom (H) and 19'-8" Transition Section for 341' Maximum Length (HJ) using Luffing Jib Sections.
216'-6" of Luffing Jib (maximum combination of 216'-6" of boom and 216'-6" of Luffing Jib.
Single Sheave Auxiliary Boom Point Extension (7'-10" long)
Main Winch with 2,952'-9" capacity of 26mm Wire Rope. Max Line Pull is 32,000lbs. 472'/min line speed
Aux Winch with 2,132'-7" capacity capacity of 26mm Wire Rope. Max Line Pull is 29,700lbs. 472'/min line speed
Aux Luffing Jib Winch is mounted in base boom section. Max. capacity of 2,329' of 26mm Wire Rope
Swing Bearing is Triple Roller Design with External Gear Drive by Dual Hydraulic Motors. Max 1.4 rpm
CTW Package consists of 330,696 lbs Upper and 88,184 lbs. Carbody for a total of 418,877
308 US-Ton, 11 Sheave (duplex hook) and 110 US-Ton, 4 Sheave (single hook) Hook Blocks are included
16.5 US-Ton Overhaul Ball with Swivel Hook and Safety Latch
Cummins QSM11, 400hp Turbocharged/Intercooled Diesel Engine (Tier 3), Fuel Tank 158.5 gallons
Fully Hydraulic Open Loop System powered by Kawasaki
Crawler Side Frames are Self-Assembling/Disassembling. 33'-10" long with 47" wide Track Shoes
Enclosed Operators Cab with Heater and A/C. A Robway LMI with Anti-Two Block System in included
Electric Over Hydraulic Crane controls via CAN Bus Technology
Current Operating Hours are less than 3,000
This crane is equipped with the correct diesel engine allowing it to operate worldwide.